MOTOR ASSEMBLY
WARNING: Assemble motor on bed as follows. While it is possible to install the motor backwards, avoid it! Incorrect installation could cause the bed to move in unexpected ways. Note that the motor ends are labeled and embossed with head and foot symbols (shown at right). Ensure that bed head and motor head, and bed foot and motor foot, are matched.
Head
Foot
Remove motor slide caps
slide cap
motor
Remove motor slide caps
1.Remove the slide caps from both ends of the motor as shown above. Plungers should be recessed in motor cavities; if not, plug the power cord into any grounded outlet and operate “down” func- tion on the pendant hand control, then unplug the power cord.
Info: Motor comes from factory with pendant hand control plugged into motor.
2. Install 9V backup battery (not provided) and slide into storage area.
Install Motors
cam
head |
foot
tap here
Install motor
3.Hold the bed securely, positioned with motor cams up, as shown above.
4.Position the motor over both cams.
5.Tap either end of the motor housing (shown below) with enough force to snap the motor as- sembly into position on the cam.
6.Repeat step 5 for other end of motor.
6 |
