| Call Progress Tones |
| Using these settings, users can configure ring or tone frequencies based on |
| |
|
|
| |||
|
|
| parameters from local telecom. By default, they are set to North American standard. |
| |
|
|
| Frequencies should be configured with known values to avoid uncomfortable high |
| |
|
|
| pitch sounds. |
| |
|
|
| Syntax: |
| |
|
|
| (Frequencies are in Hz and cadence on and off are in 10ms) |
| |
|
|
| ON is the period of ringing (“On time” in “ms”) while OFF is the period of silence. In |
| |
|
|
| order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms |
| |
|
|
| and a pause of OFF ms and then repeat the pattern. Up to three cadences are |
| |
|
|
| supported. |
| |
|
|
|
|
|
|
|
|
|
|
| |
| Intercom User ID |
| Configure intercom user ID when intercom is used. |
| |
|
|
| |||
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| |
| Disable Call Waiting |
| Default is “No”. If set to “Yes”, the call waiting feature will be disabled. |
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| |
| Disable Call |
| Default is “No”. If set to “Yes”, the call waiting tone will be disabled. |
| |
|
|
| |||
| Waiting Tone |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Disable Direct IP Calls |
| Default is “No”. If set to “Yes”, direct IP calls will be disabled. |
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| |
| Use Quick IP Call Mode |
| Dial an IP address under the same LAN/VPN segment by entering the last octet in |
| |
|
|
| |||
|
|
| the IP address. |
| |
|
|
| In the Advanced Settings page there is an option “Use Quick |
| |
|
|
| setting is “No”. When set to “Yes”, and #XXX is dialed, where X is |
| |
|
|
| <=255, phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc |
| |
|
|
| comes from the local IP address REGARDLESS of subnet mask. |
| |
|
|
| #XX or #X are also valid so leading 0 is not required (but OK). See Quick IP Call |
| |
|
|
| Mode for details. |
| |
|
|
|
|
|
|
|
|
|
|
| |
| Disable Conference |
| Default is “No”. If set to “Yes”, conference will be disabled. |
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| |
| Enable MPK Sending |
| Default is No. If set to “Yes”, |
| |
|
|
| |||
| DTMF |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Disable DND Button |
| Default is “No”. If set to “Yes”, the “DND” button on keypad will be disabled. |
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| |
| Disable Transfer |
| Default is “No”. If set to “Yes”, transfer will be disabled. |
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| |
|
| Default is “No”. If set to “Yes”, the phone will use attended transfer by default. |
| ||
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| |
| Configuration via |
| Configures the access control of configurations via the phone keypad menu. There |
| |
|
|
| |||
| Keypad Menu |
| are three modes: |
| |
|
|
| • | Unrestricted |
|
|
|
| • | Basic Settings Only |
|
|
|
| • | Constraint Mode |
|
|
|
|
|
|
|
Grandstream Networks, Inc. | GXP21xx User Manual | Page 31 of 41 |
| Firmware version: 1.0.1.66 | Last Updated: 05/2011 |