TABLE 2: DEFINITIONS OF THE HT-502 LEDS
Power LED Indicates Power. Remains ON when Power is connected and turned ON.
WAN LED Indicates LAN (or WAN) port activity.
LAN LED Indicates PC (or LAN) port activity.
PHONE1 /
PHONE2 LED
Indicate status of the respective FXS Ports-PHONE1 / PHONE2 on the back
panel
Busy - ON (Solid Green)
Available - OFF
NOTE: All LEDs display green when ON.
CONFIGURE YOUR ATA
The HT–502 is easy to configure using the embedded GUI pages and the following five (5) steps.
FIVE EASY STEPS TO CONFIGURE THE HT–502
1. Connect a standard touch-tone analog telephone (or fax machine) to first FXS port.
2. Connect another standard touch-tone analog telephone (or fax machine) to second FXS port.
3. Insert the Ethernet cable into the WAN port of HT–502 and connect the other end of the Ethernet
cable to an uplink port (a router or a modem, etc.)
4. Connect a PC to the LAN port of HT–502.
5. Insert the power adapter into the HT–502 and connect it to a wall outlet.
FIGURE 2: CONFIGURING THE HT–502
Internet ADSL/Cable
M
ode
m Eth
e
rn
e
t
WAN
LAN
FXS
F
CordlessPhone
AnalogPhone
FXS
F
CordlessPhone
AnalogPhone
Grandstream Networks, Inc. HT-502 User Manual Page 6 of 31
Firmware 1.0.0.29 Last Updated: 01/2007