UNCLOGGING GRASS CATCHER
WARNING: MOVING PARTS can cut or amputate body parts.
NEVER attempt to clear grass pump while engine is running.
ALWAYS stop unit and grass catcher engines, remove key, and wait for moving parts to stop.
Sharp edges can cut. Moving parts can cut off fingers or a hand. Wrap blade(s), wear sturdy gloves and use extreme caution when working near blades or impeller.
WARNING: PINCH POINT! Use extreme caution when unclogging grass blower. Impeller can cut or pinch your hand, even when not in operation. Wear sturdy gloves when working near impeller.
If hose or grass blower gets clogged, stop forward motion and allow unit to clear itself. If unit will not clear itself, unclog the hose/grass blower manually as instructed below.
To unclog:
1.Stop unit engine and remove ignition key. Wait for all moving parts to stop.
Stop grass catcher engine, wait for all moving parts to stop and disconnect spark plug wire.
2.Loosen hose clamp on hose.
3.Remove hose from grass blower. If clog is in hose:
1.Remove clogged grass.
2.Reinstall hose and tighten hose clamp. If clog is in grass blower:
WARNING: Impeller blades can cut or amputate fingers or hands. Block impeller blades to prevent rotation before proceeding.
1.Remove hose adapter.
2.Clear grass from blower.
3.Reinstall hose adapter and hose and tighten hose clamp.
OPERATING TIPS
•Cut grass when it is dry.
•Cut grass in two passes when cutting thick, long or wet grass. Make the first cut higher than desired. Make the second cut at desired height.
•Always use full throttle when bagging.
•Clean deck after each use to reduce clogging.
MAINTENANCE
Gravely Dealers will provide any service or adjustments which may be required to keep your unit operating at peak efficiency.
WARNING: AVOID INJURY. Read and understand Maintenance and Service in Safety section before attempting any maintenance.
MAINTENANCE SCHEDULE
The chart below shows the recommended maintenance schedule that should be performed on a regular basis.
MAINTENANCE SCHEDULE
| Each | Every 10 |
Service Performed | Use | hrs. |
|
|
|
Check Fasteners | • |
|
|
|
|
Inspect Bagger Parts | • |
|
|
|
|
Clean Unit | • |
|
|
|
|
Check Engine Oil | • |
|
|
|
|
Change Engine Oil |
| * |
|
|
|
Check Belt |
| • |
|
|
|
Lubricate Unit |
| • |
|
|
|
Check Spark Plug |
| ** |
|
|
|
*Change engine oil according to manufacturer’s recommendations. See engine manual for specific instructions.
**See engine manual for schedule and specific instructions.
CHECK FASTENERS
Be certain that all hardware is tight before each use. Pay special attention to the guards and safety shields.
GB - 8
