
Typical Installation
Greenheck's
General Flashed Roof Installation:
1.Remove roofing material where roof penetration is to be made and provide a 10‑inch wide clearance around perimeter of hole in roof.
2.Apply roofing cement around roof opening.
3.Place and center roof curb over hole in roof so it sits on roofing cement. Make sure the roof curb is placed over an adequate support structure to handle the weight and wind load of curb and fan assembly.
4.Secure roof curb to roof deck using a minimum of three lag screws, anchor bolts, or suitable metal fasteners per side and two per corner (fasteners by others).
5.Install insulation if required.
6.Field flash – flashing should extend at least 4 inches beyond the horizontal flange on roof curb. Flashing should also extend over the top flange surface where there is a wood nailer for a leak resistant installation.
7.Apply Curb Seal (rubber gasket) to the top of roof curb to seal fan or ventilator to curb to prevent air leaks and water penetration and to reduce the transmission of vibration from fan to building.
8.Place fan or ventilator onto roof curb and center.
9.Secure fan’s curb cap to the roof curb using a minimum of two lag screws, anchor bolts, or suitable metal fasteners per side (fasteners by others).
Notes:
•For rubber roofs, refer to roof manufacturer for roof curb installation.
•No replacement parts available.
•For installation of specialty curbs and high wind curbs, see CAPS for installation details.
Building Value in Air
Greenheck delivers value | top quality, innovative air- | And building owners and |
to mechanical engineers by | related equipment. We offer | occupants value the energy |
helping them solve virtually | extra value to contractors | efficiency, low maintenance |
any air quality challenges | by providing | and quiet dependable operation |
their clients face with a | competitively priced, reliable | they experience long after the |
comprehensive selection of | products that arrive on time. | construction project ends. |
Our Warranty
Greenheck warrants this equipment to be free from defects in material and workmanship for a period of one year from the purchase date. Any units or parts which prove defective during the warranty period will be replaced at our option when returned to our factory, transportation prepaid. Motors are warranted by the motor manufacturer for a period of one year. Should motors furnished by Greenheck prove defective during this period, they should be returned to the nearest authorized motor service station. Greenheck will not be responsible for any removal or installation costs.
As a result of our commitment to continuous improvement, Greenheck reserves the right to change specifications without notice.
Prepared to Support Green Building Efforts
| Roof Curbs Rev. 4 August 2008 RG |
P.O. Box 410 • Schofield, WI | Copyright © 2008 Greenheck Fan Corp. |