Greenway Home Products GWD-4650W Frequently Asked Questions, Q Why is my water dispenser leaking?

Models: GWD-4650W

1 30
Download 30 pages 34.36 Kb
Page 9
Image 9
FREQUENTLY ASKED QUESTIONS

ATTENTION: Do not return this product to the store. For questions on operation, assembly or parts, please contact us at www.greenwayhp.com or 1-866-253-0447.

FREQUENTLY ASKED QUESTIONS

Q: Why is my water dispenser leaking?

A: f you are experiencing a leak with your water dispenser please do the following to see if the water bottle or the dispenser is leaking.

1. Unplug the unit, turn off all power switches and remove the bottle.

2. Remove the bottle support collar and check the water level inside the reservoir – it should be at roughly three-quarters full. Water level should be approximately 3/4” – 1” BELOW VENT TUBE.

3. Let water sit for 2 hours. If the dispenser does not leak, it is the bottle that is leaking due to

a small crack or pinhole and it needs to be replaced. If the dispenser is leaking, please contact Greenway Home Products at support@greenwayhp.com or 1-866-253-0447.

IMPORTANT: To avoid water overflow while cleaning the dispenser, always remove the bottle support collar before pouring water or cleaning solution into the reservoir. (See Figure A, page 3).

Q: Why do I get a plastic taste from my dispenser?

A: As with most new appliances such as coffee makers and kettles, there is often a plastic taste upon

initial start-up of the unit. To remove this taste, simply follow the cleaning instructions outlined in

Cleaning the Reservoirs.

Q: What do the ready-to-dispense indicator lights mean?

A: When illuminated, they mean the following:

Red:

“flashing”

Heater is in operation

 

"on”

The hot water has reached its optimum

 

 

temperature and is ready for dispensing

Blue:

"on"

The cold water has reached its optimum

 

 

temperature and is ready for dispensing

Q: What is the spike that goes into the bottle?

A: Greenway® water dispensers feature a “piercing valve” as part of the bottle support collar, providing added convenience for water bottle installation. Depending on the water bottle supplier, a small opening may or may not be present in the bottle cap for this specific purpose. If the piercing valve opening is not present, the entire bottle cap must then be removed to eliminate possible damage to the piercing valve. If the opening is present, remove the protective seal prior to installing the bottle.

8

Page 9
Image 9
Greenway Home Products GWD-4650W Frequently Asked Questions, Q Why is my water dispenser leaking?, Cleaning the Reservoirs