4.Plug in the water dispenser.
5.Set the power switch at the rear of the dispenser to the ON position.
6.
(see Dispensing Hot Water, pg 5).
IMPORTANT NOTE: Always make sure there is water in the system before activating the on demand
IMPORTANT NOTICE ABout leaking bottles
If you find that your dispenser is leaking, check the water bottle first! Almost all 3 and 5 gallon water bottles are recycled, and handled extensively during cleaning, filling, and shipping. As a result they are very prone to developing pin holes or small cracks that can cause an overflow (or leak) when placed on top of a water dispenser.
In almost all cases, there is nothing wrong with your water
1.
dispenser. If you are experiencing a leak, this simple test will allow 2.a you to determine whether your water bottle or dispenser is the
source of the problem.
1. Unplug the unit, turn off the power switch and remove the water bottle.
2.a) Remove the bottle support collar and check the water level
inside the reservoir – it should be at roughly
b)Please add or drain a few glasses of water to achieve the
required fill level. Water level should be approximately 3/4” – 1” / 1.9cm - 2.5cm below the reservoir lip.
3. Closely monitor the water level inside the reservoir,
from the unit and call customer service at
Please visit us at www.greenwayhp.com for water dispenser accessories and helpful use and care tips.
4
