Coffee Grind Profile
Before shipment, this grinder has been tested with coffee and has been accurately adjusted to deliver a standard autodrip grind.
The Grinding Burrs are made of an extremely hard and wear resistant alloy. From time to time, grind adjustments (see instructions below) may be necessary as the burrs wear. If the grind runs coarser than expected after normal adjustment and the grind time has increased, the burrs may have excess wear and should be replaced. The burrs are warranted for 3 years or 30,000 pounds of coffee. See your warranty for details. New burrs should always be installed as a pair, never one or the other, as they are accurately ground and lapped in pairs. Old burrs cannot be resharpened.
Grind Adjustment
For Models 115A, 250, 250A, 250RH-2, 250RH-3
Tools Required: Phillips and Large Blade Screwdrivers, Pliers
In order to adjust the grind follow these steps: (see Figure D)
1.Remove Upper Front Plate by removing the four screws in the corners.
2.Loosen Adjusting Screw Lock Nut by turning counter clockwise.
3.Turn slotted Adjusting Screw clockwise to make grind finer or
Note: Use dial on grinder cap as reference. Do not turn more than one notch before testing new Grind Adjustment.
4.After adjustment has been made, tighten Adjusting Screw Lock Nut.
5.To visually inspect grind adjustment, test grind a small portion of coffee and
Adjusting Screw
Lock Nut
(86340)Adjusting Screw
(86341)
Grinder Cap (87131)
Figure D: Grind Adjustment
Note: Adjusting the grind may alter the portion of coffee dispensed. After grind adjustment, weigh portion and adjust, if necessary (see “How to Adjust the Portion”).
Current
It is absolutely essential that full voltage and amperage always be available as it takes full power to grind
coffee. NEVER connect to an overloaded line or a two or three way plug, otherwise serious damage to the motor may result.
Do not use an extension cord.
Protection
This grinder is equipped with both a circuit breaker and a shear disc to protect motor and burrs if a foreign object, such as a nail or rock, gets into the coffee.
Circuit Breaker
This grinder is equipped with a circuit breaker to protect the motor from overloading. When the circuit breaker operates, the reset button will pop out approximately 1/4” which cuts off the power to the grinder. The reset button is located above the power cord on the back of the grinder. To reset the circuit breaker, push the reset button in. You will hear a click as it resets. If the grinder does not operate after resetting the circuit breaker, there may be an obstruction in the grinding mechanism that is stalling the motor. In this case, the Grinder Head should be cleaned out as described in the Shear Disc Replacement section of this manual.
Lubrication
All bearings have been oiled for life. No further oiling is necessary.
Page 5 | 115 & 250 Series Coffee Grinders |
|
|
