Troubleshooting Guide for Grind Selector™ Mechanism (Models 115AB and 250AB)
The following procedures must be performed by a qualified service technician.
Problem | Possible Cause | Solution |
|
|
|
Loud grating noise | • Burrs are touching each other on fine | • Readjust fine grind setting, see “To |
| grind setting | Adjust Fine Grind” section |
|
|
|
Rumbling noise | • Thrust bearing rotating inside flange | • Replace thrust bearing and shear cap |
| bearing |
|
|
|
|
Chattering or buzzing noise | • Solenoid may have failed to seat or | • Check alignment of solenoid and |
| close fully (Models 115AB & | shift arm |
| 250AB only) | • Also check the tightness of the solenoid |
|
| mounting screws |
|
|
|
Loud vibration noise during grinding | • Cotter pin in the thumb screw linkage | • Attempt to spread flanges of cotter pin |
when Grind Selector™ is not activated | may be vibrating | or replace cotter pin |
|
|
|
Grind Selector™ fails to activate | • Wiring harness loose | • WITH MACHINE UNPLUGGED, check |
|
| wiring harness connections to see if |
|
| they are secure on the timer terminals |
| • Solenoid has burned out (Models 115AB | • Replace solenoid |
| & 250AB only) |
|
|
|
|
If you still need help, call our Service Department at (502)
Prior authorization must be obtained from Grindmaster Corporation’s Technical Services Department for all warranty claims.
Page 9 | 115 & 250 Series Coffee Grinders |
|
|