![](/images/new-backgrounds/1183188/18318817x1.webp)
7. Set the console assembly face down on a soft | 7 |
|
|
surface to avoid scratching the console assem- |
|
| |
|
|
| |
bly. Hold the Right Handrail (95) near the con- |
|
|
|
sole assembly. Next, insert the console wire into |
|
|
|
the large hole in the bottom of the Right | Console |
|
|
Handrail and out of the top as shown. If neces- |
|
| |
Wire |
|
| |
sary, use needlenose pliers to help pull the con- |
|
| |
|
|
| |
sole wire out. | 95 | 1 |
|
|
| ||
Attach the Right Handrail (95) and the Left |
|
| 1 |
|
|
| |
Handrail (not shown) with four #8 x 3/4" Screws |
|
|
|
(1) (only one side is shown). Make sure that no |
|
|
|
wires are pinched. Start all four Screws be- |
|
|
|
fore tightening any of them; do not over- | Console |
|
|
tighten the Screws. | Assembly |
|
|
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star | 8 | Wire |
|
Washer (33) into the bracket and Handrail |
| ||
Console |
| ||
Crossbar (94) on each side of the console as- | Wire | Tie |
|
sembly (only one side is shown). |
| 5 |
|
|
|
| |
Remove the wire tie from the console wire. |
| 33 | Bracket |
|
| ||
| Console |
|
|
| Assembly |
|
|
|
| 94 |
|
9. Remove the long tie from the Upright Wire (38). | 9 |
|
|
|
|
| |
Have a second person hold the console assem- |
|
|
|
bly near the Right Upright (78) and Left Upright |
|
|
|
(not shown). Connect the Upright Wire (38) to | Console |
|
|
the console wire. See the inset drawing. The |
|
| |
connectors should slide together easily and | Assembly |
|
|
snap into place. If they do not, turn one connec- |
|
|
|
tor and try again. IF THE CONNECTORS ARE |
|
|
|
NOT CONNECTED PROPERLY, THE CON- | Console |
|
|
SOLE MAY BE DAMAGED WHEN THE |
|
| |
POWER IS TURNED ON. | Wire |
|
|
Set the console assembly on the Right Upright | 38 |
| Console |
(78) and Left Upright (not shown). Be careful |
|
| Wire |
not to pinch the wires. | 78 | Long |
|
| Tie |
| |
|
|
| 38 |
| 9 |
|
|