ProForm PFTL78007 Make sure that the power cord is unplugged, Do not fully fold the Frame yet

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip	A
	B
the treadmill onto its left side. Partially fold the
	38
Frame (56) so that the treadmill is more stable;	Hole
do not fully fold the Frame yet.

	83	81
Remove and discard the two indicated bolts (A)	56
and the shipping bracket (B).
Cut the tie securing the Upright Wire (38) to the		2
		Tie
Base (83). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
	13
Attach a Base Pad (81) to the Base (83) in the	81
location shown with a Base Pad Spacer (13) and	2
a 1" Tek Screw (2). Then, attach another Base
Pad (81) with only a 1" Tek Screw (2).
2. Remove the 3/8" Nut (8), the 3/8" x 2" Bolt (4),	2
and the shipping bracket (C) from the Base (83).
		Tie
Attach a Wheel (84) with the Bolt and the Nut
that you just removed. Do not overtighten the		38
Nut; the Wheel must turn freely. Discard the
shipping bracket.	83
Cut the tie off the Upright Wire (38).	4
	84
	C
	8
3. Identify the Right Upright (78) and the Right	3
Upright Spacer (79), which are marked with
		78
stickers. Insert the Upright Wire (38) through the
Right Upright Spacer as shown.
See the inset drawing. Tie the long tie in the	38
Right Upright (78) securely around the end of		38
the Upright Wire (38). With the help of a second		79
person, hold the Right Upright near the Base	Long Tie
(83). Then, pull the other end of the long tie until
the Upright Wire is routed completely through
the Right Upright.
		83
	78
	38
	Long
	Tie
	7