MAINTENANCE

(TABLE 4)

Removal

1.Make sure axial movement of clamp collars - necessary for release of connection - is not resricted.

2.Relax all locking screws by at least 2 turns and transfer locking screws into all push-off threads provided in clamp collar item "1" and center collar item "3" as illustrated in Figure 2.

3.Release connection by progressively tightening all push-off screws in diametrically sequence except for screws adjacent to slit in clamp collar item "1", which should be tightened one after the other.

(TABLE 5)

General Instructions

1.The brushcutter requires a constant flow of hydraulic oil that will not be reduced when another machine function is used simultaneously.

2.Use a "Motor spool" type of control valve. If not possible, a system of recirculating check valves must be used. Circulating system and crossover relief for drive motor protection are provided with the cutter.

3.Line Sizes: All pressure lines are to be minimum 1" diameter. All return lines, 1 1/4" tubing (except when dual rotation is used-both lines must be high pressure. Flows below 30 GPM may use smaller line sizes). Confirm line size with each application.

High pressure machines use a motor capable of operating at 3500 p.s.i. with a correspondingly lower flow rate.

4.The shaft speed must not - UNDER ANY CIRCUMSTANCES - exceed 1800 RPM.

5.Secure all wear parts as per factory original installation. (Follwing servicing, sharpening, etc.)

GRIZZLY 52 01/05

Maintenance Section 5-8

© 2005 Alamo Group Inc.

Page 46
Image 46
Grizzly 52 manual General Instructions, Removal