g0457 14" industrial Bandsaw (Mfg. Since 5/11) -17-
7. thread an M8-1.25 hex nut all the way onto
the quick release lever, as shown in figure
11, then thread the lever into the quick
release hub and tighten the hex nut against
the hub to lock the lever in place.
figure 11. Quick release lever installed.
hex nut
8. have an assistant hold the motor in position
against the backside of the frame, as shown
in figure 12.
figure 12. installing motor (outside view).
10. place the belt on the pulleys and pivot the
motor so the belt is tight, then tighten the cap
screws. refer to Tensioning v-Belt on page
45 to properly tension the drive belt.
11. refer to Wiring on page 51 and wire the
motor to the switch cord.
12. remove the blade from the top and bottom
wheels, then remove the table pin and table
insert from the table.
13. place the table bolts through the trunnions.
14. thread the table trunnion hand knobs onto
the table bolts to secure the table (figure
14).
figure 13. installing motor (inside view).
9. From the inside of the bandsaw, loosely fas-
ten the motor to the body with the cap screws
and flat washers, as shown in figure 13.
figure 14. table installed on trunnions.
hand
Knob
Wheel removed
for Clarity