Spindle Height
Control
Spindle height is changed by unlocking the quill lock lever and the fine feed knob, and using the quill feed handles or the fine feed knob (Figure 12). The spindle scale indicates the spindle height in inches and millimeters.
To change the spindle position:
1.Unlock the quill lock lever and loosen the fine feed lock knob.
2.Pull down on the quill feed levers to lower or raise the spindle. Lock the quill lock to hold the spindle in a particular position if you choose.
3.Tighten the fine feed lock knob and use the fine feed knob if you like.
Tip: Milling with the quill fully extended, can cause tool chatter. For maximum spindle rigidity when milling, keep the spindle retract- ed into the headstock as far as possible, lock the headstock and quill lock levers, and tighten the fine feed lock knob.
Spindle Scale | Quill Feed Lever |
Fine Feed Knob | |
Quill Lock Lever | Fine Feed Lock Knob |
Figure 12. Spindle controls.
Table Travel (X-Axis
and
Longitudinal Feed
The longitudinal feed, or
Cross Feed
The cross feed, or
Headstock Travel
The vertical headstock travel, or
G0484 Gear Head Mill/Drill |