-12- G0528 Sliding Router Table

Cross Supports

Components Needed: Qty
Table Assembly ..................................................1
Table Cross Supports .........................................3
Rubber Stops .....................................................2
Cap Screws 516"-18 x 112" ..................................2
Flat Washers 516" ................................................8
Hex Nuts 516"-18 .................................................4
Hex Bolts 516"-18 x 1" .........................................2
Tools Needed:
12mm Wrench or Socket ....................................1
6mm Allen Wrench .............................................1
To attach the table to the stand:
1. Place the table assembly face-down on the
floor.
2. Position the table cross supports on the table
assembly and align the bolt holes (Figure
5).
Figure 5. Table cross supports.
3. Secure bolt holes “A” (Figure 5) with 2 hex
bolts, 4 flat washers, and 2 hex nuts.
4. Secure bolts holes “B” (Figure 5) with the
rubber stops, 2 cap screws, 4 flat washers,
and 2 hex nuts (Figure 6).
Figure 6. Securing cross supports to table.
Bolt Holes “A”
Bolt Holes “B”