-14- G0528 Sliding Router Table
Components Needed: Qty
Left Fence .........................................................1
Right Fence ........................................................1
Dust Hood ..........................................................1
Fence Lock Handles ...........................................2
Tools Needed:
10mm Wrench or Socket ....................................1
11mm Wrench or Socket ....................................1
To attach the fence assembly:
1. Secure the left and right fence assemblies
to the table with the fence lock handles.
Note—Use the holes located closest to the
edge of the cast iron table.
2. Secure the dust hood to the top of each
fence assembly (Figure 9).
Figure 9. Installed fence and dust hood.
Dust Hood
Components Needed: Qty
Workpiece Hold-Down Assemblies ....................2
Tools Needed:
19mm Wrench ....................................................1
To attach the hold-downs:
1. Remove one of the hex bolts from each of
the hold-down brackets.
2. Slide the hold-down brackets through the
mounting holes on the dust cover and secure
them from the underside of the dust cover
with the hex nuts removed in step 1.
3. Tighten the hex nuts until the hold-down
brackets are secure.
4. Secure the hold-down finders to the hold-
down brackets by tightening the threaded
star knob (Figure 10). Note—Do not worry
about precise placement of the hold-down
brackets or fingers at this time.
Figure 10. Installed hold-down assemblies.
Workpiece Hold-
Down Assemblies
Threaded Star
Knobs