Table Inserts
The table inserts minimize the gap between the working surface edge and the spindle. It is impor- tant to use the proper table insert according to the diameter spindle you are using.
The Model G5029 comes with the following four table inserts:
¥2"
¥1"
¥2" elliptical
¥1" elliptical
Select the table insert that comes closest the spindle sleeve diameter without touching it. The elliptical inserts are used when sanding with the table tilted.
Place the table insert into the table hole as shown in Figure 7.
!
Figure 7. Installing table inserts.
Squaring Table
To square the sanding tables:
1.Disconnect the machine from the power sup- ply.
2.Set the table at 90û as shown in Figure 8.
!
Pointer
Figure 8. Setting the table scale at 90û.
3.Place a machinist square on the table and against the sanding spindle to verify the table is 90û from the edge of the sanding sleeve as shown in Figure 9.
4.Adjust the pointer to 90û.
!
Figure 9. Squaring the table and spindle.
G0529 Oscillating Spindle & Disc Sander |
