Sanding Disc

Installation

The disc sander requires 12" sanding discs with hook and loop backing.

To install a new sanding disc on the 12" disc sanding surface:

1.Disconnect the machine from the power sup- ply.

2.Remove the disc sanding table.

3.Remove the old sanding disc.

4.Install the new sanding disc as shown in Figure 12.

!

Figure 12. Installing sanding disc.

Aligning Table

The table must be aligned to the face of the sand- ing disc so that the sandpaper does not rub against the table.

To align the table:

1.Loosen the bolts that secure the table to the table support bracket as shown in Figure 13.

!

Figure 13. Loosening table bolts.

2.Align the table so that there is a 1Ú16'' gap between the 12" disc and the table.

3.Tighten the bolts loosened in step 1.

4.Spin the disc by hand to check if the sand- paper is touching the table. NoteÑDO NOT turn the disc sander on at this point.

5.Repeat steps 1-3if the sandpaper touches table at any point in the rotation.

 

 

 

 

 

 

 

 

 

 

 

 

-16-

G0529 Oscillating Spindle & Disc Sander

Page 18
Image 18
Grizzly G0529 instruction manual Sanding Disc Installation, Aligning Table, To align the table