Base and Supports

Components and Hardware Needed:

QTY

Base

1

Casters

4

Round Support

1

Rectangle Support

2

Impeller/Separator

2

Handle

1

Hex Bolts 516"-18 x 12"

6

Hex Bolts M6-1.0 x 10

4

Acorn Nuts 516"-18

4

Flat Head Screws M6-1.0 x 10

2

Phlips Screw 10-24 x 38"

1

Flat Washers 516"-18

2

Tools Needed:

 

Wrench or Socket 12mm

1

#2 Phillips Screwdriver

1

To assemble the dust collector base:

 

1.Make sure the dust collector motor is unplugged!

2.Install the the casters with the four 516"-18 acorn nuts and washers. (see Figure 6).

Figure 6. Installing casters.

4.Place the round and rectangle supports on the base and install with six 516"-18 x 516" hex bolts (see Figure 7).

Figure 7. Impeller/separator supports.

5.Align the impeller/separator assembly with the supports, and install six 516"-18 x 12" hex bolts (see Figure 8).

6.Position the elbow as shown in Figure 8, and secure it in place with the #10-24 x 38" phlips head screw.

7.Position the handle as shown in Figure 8, and secure it in place with two M6-1 x 10 flat head screws.

Figure 8. Impeller/separator attached to base.

G0583 1 HP Canister Dust Collector

-13-

Page 15
Image 15
Grizzly G0583 instruction manual Base and Supports, Components and Hardware Needed, Tools Needed