Canister Filter |
|
Components and Hardware Needed: | QTY |
Canister Filter | 1 |
Handle | 1 |
Metal Canister Clamp | 1 |
Narrow Foam Strip | 1 |
Tools Needed: |
|
Hex Wrench 3mm | 1 |
To install the canister: |
|
1.Secure the narrow foam strip around the outside top rim of the collector as shown in Figure 9.
Figure 9. Narrow foam strip.
2.Trim the excess foam strip so the ends come together evenly as shown in Figure 9.
3.Install the handle onto the top of the canister and tighten the set screw against the flat of the shaft (Figure 10).
Shaft Flat
Figure 10. Installing canister handle.
4.Place the canister on top of the collector.
5.Position the metal canister clamp around the bottom of the canister filter, so it will com- press around the foam strip (Figure 11), and latch the clamp closed.
Figure 11. Installed and secured canister filter.
G0583 1 HP Canister Dust Collector |
