Grizzly G0640X Inventory

G0640X 17" Wood/Metal Bandsaw -11-

After all parts have been removed from the three

boxes, you should have the following items:

Main Components: (Figure 2 & 3) Qty

A. Bandsaw (not shown) .................................1

B. Table ..........................................................1

C. Miter Gauge ................................................1

D. Fence Assembly .........................................1

E. Resaw Fence Attachment ..........................1

F. Front Fence Rail .........................................1

G. Rear Fence Rail .........................................1

H. Handwheel (not shown) ............................. 1

I. V-Belt A27 (not shown) ..............................1

J. Scale (not shown) ...................................... 1

Fasteners (and where used): Qty

Hex Bolt M8-1.25 x 100 (Positive Stop) ............1

Hex Nut M8-1.25 (Positive Stop) .......................1

Cap Screw M6-1 x 20 (Handwheel) ..................1

Hex Bolts M8-1.25 x 16 (Table) ........................ 4

Lock Washers 8mm (Table) ..............................4

Flat Washers 8mm (Table) ................................4

Cap Screws M6-1 x 25 (Rear Rail) ................... 2

Hex Bolts M6-1 x 20 (Front Rail) .......................2

Lock Washers 6mm (Front Rail) ....................... 2

Flat Washers 6mm (Front Rail) .........................2

Hex Nut M8-1.25 (Fence Lock Lever) ...............1

Hex Nut M6-1 (Rail Pad) ...................................1

Flat Washer 8mm (Attachment Lock Handle) ...1

Tools & Other Miscellaneous Items: Qty

Hex Wrench 5mm ..............................................1

Hex Wrench 8mm ..............................................1

Open End Wrench 10/13mm .............................1

Table Pin ...........................................................1

Table Insert .......................................................1

Rail Pad M6-1 x 18 (attaches to fence) ............ 1

Fence Lock Lever M8-1.25 x 22 ....................... 1

Fence Attachment Lock Handle M8-1.25 x 44 ..1

Fence Attachment T-Slot Nut ............................1

Figure 2. Bandsaw components.

Figure 3. Fence components.

If any nonproprietar y par ts are missing (e.g. a

nut or a washer), we will gladly replace them, or

for the sake of expediency, replacements can be

obtained at your local hardware store.

NOTICE

Some hardware/ fasteners on th e inventory

list may arrive pre-installed on the machine.

Check these locations before assuming that

any items from the inventory list are miss-

ing.

Inventory