-44- Model G0747/G0748 (Mfg. Since 8/12)
the mill has numerous moving metal -to-metal
contacts that require regular and proper lubrica-
tion to ensure efficient and long-lasting operation,
and to protect your investment.
other than the lubrication points covered in this
section, all other bearings are internally lubricated
and sealed at the factor y. simply leave them
alone unless they need to be replaced.
Before performing any lubrication task,
disConneCt the Mill FroM poWer!
Important: Before adding lubricant, clean the
debris and grime from the oil cup or grease fitting
and the immediate area to prevent contamination
of the new lubricant.
use the schedule and information in Figure 51
as a daily guide for lubrication tasks. Follow the
referenced sections on the following pages for
detailed instructions.
Lubrication
The following recommended lubrication
schedule is based on light to medium mill
usage. Keeping in mind that lubrication
helps to protect the value and operation of
the mill, you may need to perform the lubri-
cation tasks more frequently depending on
your usage.
Lubrication Task
Frequency
(Hours of
Operation)
Page
Ref.
Quill 4 hrs. This
Page
table Ways (one-shot
oiler) 4–8 hrs. 45
headstock gearing 40 hrs. 45
ram Ways 40 hrs. 46
table elevation leadscrew
(z-Axis) 40 hrs. 46
power Feed gears 160 hrs. 47
Figure 51. recommended lubrication tasks,
schedules, and instruction page references.

Quill

oil type ...... Model t23962 or iso 68 equivalent
oil Amount ..........................................Fill oil Cup
Check/Add Frequency ............4 hrs. of operation
lift the quill oil cup cap shown in Figure 52 to add
10 drops of lubricant.
Failure to follow reasonable lubrication
practices as instructed in this manual for
the mill could lead to premature failure of
the mill and will void the warranty.
Figure 52. Quill oil cup.
Quill oil Cup