Grizzly G1030Z2 owner manual Plastic Blast Gate

Be sure that you extend the bare copper wire down all branches of the system. Do not forget to connect the wires to each other with wire nuts when two branches meet at a “Y” or “T” connec- tion.

Ensure that the entire system is grounded. If using plastic blast gates to direct air flow, the ground- ing wire must be jumped (Figure 44) around the blast gate without interruption to the grounding system.

Plastic Blast

Gate

Copper	Metal Duct
Ground Wire

Figure 44. Ground jumper wire when using

plastic blast gates and metal duct.

Model G0562Z/ZP, G1030Z2/Z2P (Mfg. 11/11+)

External Ground Wire
Internal Ground	Ground Screw
Wire

Flex-Hose

Figure 45. Flex-hose grounded to machine.

We also recommend wrapping the outside of all plastic ducts with bare copper wire to ground the outside of the system against static electrical build up. Wire connections at Y’s and T’s should be made with wire nuts.

Attach the bare ground wire to each stationary woodworking machine and attach to the dust collector frame with a ground screw as shown in Figure 45. Ensure that each machine is continu- ously grounded to the grounding terminal in your electric service panel.

-27-