Grizzly G1060 instruction manual Clean up Site Considerations

Clean up Site Considerations

The working table for the G1060 is coated with a waxy oil that protects them from corrosion during shipment. Remove the protective coating with mineral spirits and paper towels. Do not use gasoline or other petroleum based solvents because of their extremely low flash points. Do not use chlorine-based solvents – if you happen to splash some onto a painted surface, you’ll ruin the finish.

WARNING!

Follow the safety rules listed below when working with solvents:

1.Read and follow all directions and warnings on the solvent label.

2.Work only in a well ventilated area.

3.Do not work near any type of open flame (e.g., pilot lights, kerosene heaters, and so on).

4.DO NOT smoke while working with flamma- ble material.

5.Paper towels from the cleaning process are extremely combustible. Dispose of waste towels so they do not create a fire hazard.

1.Working Clearances: Consider existing and anticipated needs, size of material to be processed through the machine, and space for auxiliary stands, work tables or other machinery when establishing a location for your scroll saw.

2.Lighting and Outlets: Lighting should be bright enough to eliminate shadow and pre- vent eye strain. Electrical circuits should be dedicated or large enough to handle amper- age requirements. Outlets should be located near each machine so power or extension cords are clear of high-traffic areas. Observe local electrical codes for proper installation of new lighting, outlets, or circuits.

G1060 22'' Scroll Saw -7-