![](/images/new-backgrounds/1241049/24104925x1.webp)
Disc Table |
| Belt Lever |
|
|
|
|
|
|
The disc table adjusts to allow you to sand your work at angles from
1.Loosen the two star knobs at either end of the disc table base until they reach the ends of their threaded rods.
2.Move the sliding rails and the washers to allow enough room for the table to be installed.
3.Flip the 90° stop block out of position.
4.Install table securely between the two slid- ing rails as shown in Figure 6.
5.Tighten star knobs to secure the table in position.
Figure 6. Attaching disc table.
The belt lever is used for releasing the tension on the idler pulley for belt installation. To attach the belt lever:
1.Thread the belt lever onto the loosen/tighten collar and secure with the checknut. See Figure 7.
Belt Lever
Loosen/Tighten Collar
Figure 7. Attaching belt lever.
DO NOT attempt to operate this machine before completing the assembly and adjust- ment instructions. Be sure that the switch is off and the cord is disconnected from the power source at all times until assembly and adjustment are complete and you have reviewed all safety guidelines. Serious injury could occur.
NOTICE
After all parts have been assembled, dou-
G1183/1276 Combination Sander |