Grizzly G7212, G7211 instruction manual Maintenance, TableV-Belts

SECTION 7: MAINTENANCE

TableV-Belts

The table and other non-painted surfaces on the Model G7211/7212 should be protected against rust and pitting. Wiping the saw clean after every use ensures that moisture from wood dust isnÕt allowed to trap moisture against bare metal sur- faces.

Some woodworkers recommend using automo- tive paste wax on exposed steel and cast iron sur- faces. The wax provides a layer of protection, as well as reducing friction between lumber and the table, making cuts faster and smoother. Avoid waxes that contain silicone or other synthetic ingredients. These materials can find their way into lumber thatÕs being worked, and can make staining and finishing difficult. If you use paste wax, make sure that itÕs 100% Carnauba wax.

NOTICE

Do not use paraffin or similar waxes on your saw’s table. They can leave residues which will make cutting more difficult over time. Do not use silicon based lubricants. They can rub off onto the wood and prevent it from taking stains and finishes properly.

To ensure optimum power transmission from the motor to the blade, the V-belt must be in good condition and operate under proper tension. Belts should be checked for cracks, fraying and wear. Belt tension should be checked at least every 3 months; more often if the bandsaw is used daily.

The V-belts are accessed via the bottom cover:

1.Squeeze the center of each V-belt.

2.Note the amount of deflection. Deflection should be approximately 3Ú4".

DO NOT make adjustments or attempt main- tenance procedures while the Model G7211/G7212 is running. Ensure that the switch is off, power is disconnected and moving parts have stopped before making adjustments. Failure to comply may result in serious personal injury.

Operating this equipment has the potential to propel debris into the air which can cause eye injury. Always wear safety glasses or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).

-20- G7211/7212 24" Bandsaw