Grizzly G7946 instruction manual Table Support, G7945 table and support

Table Support

The Model G7945 comes with a one piece square table and support as shown in Figure 4. The Model G7946 comes with a round table and two piece hinged table support.

1.Insert the pinion gear into the hole on the side of the bracket from the inside, starting with the shaft. See Figure 5. Align the setscrew in the crank with the flat portion of the pinion gear shaft. Secure with a 3mm Allen® wrench.

2.The rack has teeth that extend farther on one end than the other. This end must be posi- tioned down. Insert the rack into the table sup- port bracket and position in the pocket. Be sure that the gear teeth are positioned out. See Figure 6.

3.While holding the rack in place, slide the table support bracket over the column. Allow the bracket and rack to slide down the column until the bottom of the rack contacts the shoul- der of the column support. Secure the table bracket by tightening the lock handle.

4.Slide the column ring onto the top end of the column with the inside bevel downward. See Figure 7. Move the ring around until the tip of the rack fits inside the bevel.

NOTICE

Do not over-tighten the setscrew in the col- umn ring, as it may split the ring.

Figure 4. G7945 table and support.

-10-

Pinion Gear

Figure 5. Insert the pinion gear from the inside.

Figure 6. Rack orientation (G7946 shown).

Do not overtighten.

Figure 7. Inside bevel in the correct position.

G7945/46 Radial Drill Press