![](/images/new-backgrounds/1150160/15016029x1.webp)
Depth Stop
Your radial drill press comes with a depth stop for use when drilling. Follow the instructions below for use.
1.Loosen the depth collar lock knob. See Figure 11.
2.Secure the wood stock you will be drilling onto the drill press table.
3.With the desired bit installed, lower the spin- dle until the tip of the bit just touches the wood stock you will be drilling. Hold the spin- dle in this position.
4.Turn the depth collar to the desired depth indicated by the scale on the collar. Secure the collar by tightening the lock knob.
3.Remove the wood stock and test the depth stop by measuring how far the spindle travels when the handles are rotated. See Figure 12.
Figure 11. Loosening collar lock knob.
You can also lock the spindle in the down posi- tion for operations such as spindle sanding.
1.Loosen the depth collar lock knob. See Figure 11.
2.Rotate the spindle to the desired depth and hold it steady.
3. Rotate the the collar clockwise until it stops, and tighten the lock knob.
4.Slowly release the drill press handle and the spindle should not move.
Figure 12. Actual stop depth being measured.
G7945/46 Radial Drill Press |