Grizzly G9717 SSEECCTTIIOONN 44:: AASSSSEEMMBBLLYY

G9717 6" Grinder

-6-

SSEECCTTIIOONN 44:: AASSSSEEMMBBLLYY

The Tool Rest provides a surface which can be

used to support the workpiece during grinding.

Certain types of grinding may require jigs or

accessories to assure the proper angle of the

piece against the wheel.

The Tool Rest assembles to the inboard side of

the Wheel Guard. Use two (2) hex bolts and lock-

washers inserted through the rest support and

thread into the tapped holes. Repeat this installa-

tion for the opposite side wheel. The Tool Rest

can be adjusted in and out by loosening these

bolts. Always retighten before beginning grinding

operations.

The Eye Shield should be positioned between the

grinding wheel and the operator’s face during

grinding. This lessens the possibility for sparks or

metal bits to go flying directly at the operator.

The Eye Shield has a clear plastic panel which is

attached to a support bracket. Thread the long

Phillips® head screw through the bracket, then

through the shield, and then through the other

side of the bracket. Use a nut and lockwasher,

but leave it loose enough so the angle of the Eye

Shield can be adjusted.

Attach the support bracket to the top end of the

wheel rim guard with a Phillips® head screw, flat

washer and lockwasher into the tapped hole.

Note that there is a slot in the support bracket

which allow adjusting the Eye Shield up and

down.

Repeat the Eye Shield installation for the oppo-

site side wheel.

FFiigguurree 22.. Tool rest installed.

FFiigguurree 33.. Eye shield in operating position.