Grizzly Circuit Requirements, G9967/G9967Z G9740/G9740Z, Recommended Plug and Receptacle

SECTION 3: CIRCUIT REQUIREMENTS

G9967/G9967Z G9740/G9740Z

The Model G9967/G9967Z Planer is prewired with a 5 HP 220V single-phase motor. Please use the following specs when preparing your shop for the machine, and always have the wiring inspected by a licensed electrician before operat- ing your machine.

Total Amperage Draw		39 amp
Recommended Circuit Breaker		40 amp
Recommended Plug and Receptacle		....... 6-50
Cord	2-pole, 3-wire

The planer must be connected to a dedicated circuit. It should not share a circuit with any other machine. If frequent circuit failure occurs when using the planer, contact our Service Department.

In addition, you may also “hard-wire” the planer directly to your panel, provided you place a dis- connect near the machine. Check the electrical codes in your area for specifics on wiring require- ments.

Figure 1. Typical 6-50 plug and receptacle.

The Model G9740/G9740Z is prewired with a 71⁄2 HP 220V 3-phase motor, which may be rewired to 440V. Please use the following specs preparing your shop for the machine, and always have the wiring inspected by licensed electrician before operating your machine.

Total Amperage Draw at 220V	.............. 26 amp
Circuit Breaker at 220V	30 amp
Plug and Receptacle at 220V	L15-30
Total Amperage Draw at 440V	.............. 13 amp
Circuit Breaker at 440V	15 amp
Plug and Receptacle at 440V	L16-20
Cord	3-pole, 4-wire

The planer must be connected to a dedicated circuit. It should not share a circuit with any other machine. If frequent circuit failure occurs when using the planer, contact our Service Department.

In addition, you may also “hard-wire” the planer directly to your panel, provided you place a dis- connect near the machine. Check the electrical codes in your area for specifics on wiring require- ments.

Figure 2. Typical L15-30 plug and receptacle.

-6- Extreme Duty Planers