SECTION 9: SERVICE ADJUSTMENTS
Always disconnect power to the machine before performing ser- vice adjustments. Failure to do this may result in serious personal injury.
Planer knives are danger- ously sharp! Use extreme caution when working near cutting surfaces. Failure to exercise care while working near knives could result in severe injury.
About Service
This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.
This section is provided for your convenience— it is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570)
Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.
Adjustment Controls
Figures 5 and 6 point out the primary controls and components that will be used during the adjustment process. Take a few minutes to famil- iarize yourself with these.
Cutterhead Lock |
|
| Height Knob |
Table Height |
|
Lock |
|
Height Controls |
|
Figure 5. Planer controls.
| Cutterhead |
Pressure | Chip Breaker |
Bar |
|
Rear Feed | Front Feed |
Roller | |
Roller | |
| |
| Claw |
| Bed |
| Rollers |
Table | Bed Roller |
| Height Lever |
Figure 6. Planer components.
Extreme Duty Planers |
