OPERATIONS
Changing Bits
1.Remove the chuck key from the hold- er on the power cord.
2.Insert the chuck key into one of the three holes located on the side of the chuck.
3.Turn the chuck key counterclockwise. This will cause the three chuck jaws to open. When the chuck jaws are at the approximate diameter of the bit or driver, insert the shank end of the bit or driver into the jaw opening.
5.Turn the chuck key clockwise until the jaws close tightly around the bit or dri- ver. Never “power tighten” which is holding the chuck while running the drill. This can cause serious injury to the operator’s hands. Check for tight- ness periodically while using the tool.
6.To release the bit or driver, insert the chuck key and turn
Operating this equipment has the potential to propel debris into the air which can cause eye injury. Always wear safety glasses or goggles when operating equipment. Be cer- tain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).
Operating this equipment has the potential for flying debris to cause eye injury. Always wear safety glasses or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).
Like all power tools, there is danger associated with the Model G9909. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this tool with respect and caution to lessen the possibility of operator injury. If normal safety pre- cautions are overlooked or ignored, serious personal injury may occur.
The Model H0777 was specifically designed for boring holes. DO NOT
MODIFY AND/OR USE THIS MACHINE FOR ANY OTHER PUR- POSE. Modifications or improper use of this tool will void the warran- ty. If you are confused about any
aspect of this machine, DO NOT use it until you have answered all your ques-
tions. Serious personal injury may occur.
H0777 |
