12.Position the tool rest approximately 1⁄4" away from the workpiece and approximately 1⁄8" above the center line, as shown in Figure 15.
���������
��������� 
����
���� 
�����������
���������
Figure 15. Tool rest set 1⁄8" above the center line and 1⁄4" away from workpiece.
13.Test the setup by hand turning the workpiece to make sure there is enough clearance all the way around before starting.
Spindle Turning Tips:
•When turning the drill ON, stand to the side of the spinning direction until the lathe reaches full speed and you can verify that the lathe will not throw the workpiece.
•Use the slowest speed when starting or stop- ping the lathe, and when rough cutting.
•Select the right speed for the size of work- piece you are turning. Use slower speeds for large workpieces (4" diameter and over); use the middle range speeds for medium sized workpieces (2" to 4" diameter); and use faster speeds for small sized workpieces (under 2" in diameter).
•Keep the turning tool on the toolrest the ENTIRE time that it is in contact with the workpiece.
•Learn the correct techniques for each tool you will use. If you are unsure, read books or magazines about lathe techniques and seek training from experienced users.
In addition to spindle turning, your hobby lathe can be used for faceplate turning (commonly used to turn bowls), as well as for and disc sanding.
Faceplate turning and disc sanding are shown in Figures 16 & 17.
Faceplate
Figure 16. Typical faceplate turning setup.
Sanding Disc
Sanding
Table
Figure 17. Typical disc sanding setup.
A comprehensive review of all lathe operations is beyond the scope of this manual. You will enjoy your lathe more if you take some time to consult reference books on lathe equipment and wood- turning techniques.
Your Grizzly catalog is an excellent source for lathe tools and accessories, including those shown in SECTION 4.
H2669 Hobby Lathe |
