Grizzly H2669 owner manual Test Run, To test run the machine

Make sure the machine is setup properly.

7.Re-mount the tailstock to the lathe bed as shown in Figure 10. Position it temporarily a few inches from the end of the lathe bed and hand tighten the hex head bolt.

Hex Head Bolt

Figure 10. Mounting the tailstock.

Test Run

When assembly is complete, test run your machine to make sure it runs properly.

To test run the machine:

1.Make sure you have read and understand the safety instructions given at the beginning of this manual.

2.

3.Make sure all tools and objects used during setup are clear of the machine

4.Connect the drill to the power source.

5. Turn the drill ON.

6.Listen for abnormal noises and watch care- fully for abnormal actions. The machine should run smoothly with little vibration or rubbing noises.

—If the machine runs smoothly with little or no vibration and no rubbing noises, then turn the drill OFF and proceed to OPERATIONS on Page 12.

—If, during the test run, you cannot easily locate the source of an unusual noise or vibration, then turn the drill OFF imme- diately and review Troubleshooting on Page 18. If you still cannot remedy a prob- lem, contact our Tech Support at (570) 546-9663 for assistance.

-12- H2669 Hobby Lathe