Grizzly instruction sheet Model H2882, 71⁄2 Pneumatic Drum, Sander, Instruction Sheet

MODEL H2882

71⁄2" PNEUMATIC DRUM

SANDER

INSTRUCTION SHEET

EYE/EAR INJURY HAZARD! Wear safety glasses and hearing protection during use of this tool!

OVER INFLATION HAZARD!

Never exceed 8 PSI!

RESPIRATORY HAZARD! Sanding produces fine dust. Wear the appropriate protection during use!

Introduction

This rolling-pin style pneumatic drum sander is perfect for hand contouring and smoothing proj- ects that are too large to use with a stationary sander. Simply chuck the 3⁄8" spindle into a por- table electric drill, cordless drill or air powered drill for two-handed control. Choose this 71⁄2" x 21⁄4" diameter size for getting into tight areas. Features ball bearing handle and air valve for easy bicycle pump inflation.

Inventory
A.	Drum Sander	1
B.	Spare Valve Cap	1

Operation

Slide the sanding sleeve over the drum. Remove the plastic cap on the handle with a small screw driver to expose the air valve. Inflate to the desired pressure. DO NOT exceed 8 PSI!

Figure 1. Model H2882.

Figure 2. Model H2882 in action.

71⁄2" Aluminum Oxide Sanding Sleeves

H3881 21⁄4" x 71⁄2" x 60 Grit

H3882 21⁄4" x 71⁄2" x 100 Grit

H3883 21⁄4" x 71⁄2" x 150 Grit

H3884 21⁄4" x 71⁄2" x 180 Grit

H3885 21⁄4" x 71⁄2" x 220 Grit

H3886 21⁄4" x 71⁄2" x 320 Grit

If you need help with your new pneumatic tool, call our Tech Support at: (570) 546-9663.

COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#PC8029 PRINTED IN TAIWAN