Grizzly H2913, H2912 instruction manual Operation, Loading The Nailer/Stapler, Depth Adjustment

OPERATION

Loading The Nailer/Stapler

To load your nailer/stapler:

1.Disconnect the air supply from the nailer/stapler!

2.Push the magazine latch in the direc- tion shown in Figure 1.

Figure 1. Releasing magazine latch.

3.Pull back the magazine cover until it stops.

4.Point the nailer/stapler up and insert a stick of nails/staples into the maga- zine as shown in Figure 2. Make sure that the pointed ends of the nails/sta- plers point in the same direction as the Model H2912/H2913 nose and the nails/staples rest in the slot at the bot- tom of the magazine.

Figure 2. Loading the nailer/stapler.

5.Push the magazine cover forward until the magazine latch locks in place.

Depth Adjustment

1.Rotate the depth adjustment wheel (shown in Figure 3) clockwise to increase the nail/staple driving depth.

2.Rotate the finger wheel counter-clock- wise to decrease the nail/staple dri- ving depth.

Figure 3. Depth adjustment wheel.

Operating The Nailer/Stapler

If you have not read the safety instruc- tions in this manual, do not operate the nailer/stapler.

Before you operate your nailer/stapler, place one drop of the included oil into the quick connect fitting where the nailer/sta- pler connects to the air supply. Fire the EMPTY nailer/stapler 3-4 times before beginning, so oil does not come out onto the project during regular operation.

H2912/H2913 2-IN-1 NAILER/STAPLER -6-