ASSEMBLY INSTRUCTIONS
When assembling the Model H3034, tighten all nuts and bolts finger tight, then, when the cart is assembled, tighten all nuts and bolts firmly.
FENCES, HANDLES, AND LEGS
1.Bolt the fence sides to the inside of the base using the
2.Install the tailgate with the hinges facing out, using the
Figure 3. Tailgate hinges.
3.Bolt the legs to the base (Figure 4) using M8- 1.25 x 40 hex bolts, flat washers, and lock nuts. Bolt them to the sides using M8-1.25 x 45 hex bolts, flat washers and lock nuts.
4.Slide the handle through the handle housing rings and fasten with M8-1.25 x 40 hex bolts, and lock nuts for the ends, and M8-1.25 x 16 hex bolts for the threaded housing rings (Figure 4).
5.Place the support bar in the bracket on the base and bolt the ends to the legs with M8- 1.25 x 40 hex bolts, flat washers and lock nuts (Figure 4).
6.Secure the support bar in the bracket with a M8-1.25 x 40 hex bolt, flat washer and lock nut (Figure 4).
AXLE AND WHEELS
1.With the cart upside down, place the axle through the axle housing on the bottom of the base.
2.Place a wheel and a 20mm flat washer on each axle end.
3.Insert and spread a cotter pin through each axle.
If you need additional help with this procedure, call our service department at: (570)
