Grizzly H3098 Position Marks, Fingerboard to Neck, To install the position marks

Position Marks

The position mark holes have been predrilled into the side of the fingerboard.

To install the position marks:

1.Place a small drop of glue in each position mark hole.

2.Slide the end of the position mark stick into a hole and use a sharp knife to cut it flush with the fingerboard. Note—Sand the position marks flush with the fingerboard edge.

Fingerboard to Neck

To attach the fingerboard to the neck:

1.Using a straightedge, make sure the neck and body surface are flush.

2.Using rubber bands and small sticks of wood, secure the fingerboard to the neck with a thin, even layer of wood glue (Figure 7). Note—Make sure the fingerboard is cen- tered across the width of the neck and that the 14th fret is centered over the neck to body joint.

Figure 7. Securing the fingerboard to the neck.

3.Using a file or sandpaper, make the edge of the neck flush with the edge of the finger- board.

H3098 Western Guitar Kit -9-