Clearing Jammed Nails
To clear a jammed nail from the dis- charge area on the Model H5570:
1.Disconnect the nailer from the air supply!
2.Pull the spring loaded pusher all the way back and remove the nail stick.
3.Flip up the quick release latch located on top of the nailer nose assembly as shown in Figure 6.
4.Remove the driver guide cover as shown in Figure 7.
5.The jammed nail should now be visi- ble; remove it from the discharge area with needle nose pliers.
6.Replace the driver guide cover and snap the quick release latch back into operating position.
Figure 6. Releasing guide cover latch.
Figure 7. Removing driver guide cover.
Always disconnect air from nailer whenever clearing a jammed nail!
Cleaning Nailer
Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again.
Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nail- er; this may result in leaks and damage to the nailer and the air couplings.
Never use gasoline or other flamma- ble liquids to clean this tool. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!
H5570 18 Gauge Finish Angle Nailer |
