Grizzly H5570 instruction manual Operation, Oiling Nailer, Loading Nailer

OPERATION

Oiling Nailer

Special oil has been included with your new Grizzly nailer to help maintain its use- ful life. Place one drop of oil in the nailer air inlet (as shown in Figure 1) before every use. Wipe off any excess oil near the nail- er exhaust to avoid dust build-up. When the oil that was included with the nailer has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

Another option to manual oiling would be to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your nailer will not be necessary. Just make sure there is always oil in the lubricator.

As mentioned before, the best option is to install a filter/lubricator/regulator unit such as the Grizzly Model H4196 in your air line.

Figure 1. Lubricating nailer via air inlet.

Loading Nailer

When replacing nails in your Model H5570, follow these guidelines:

Gauge: 18

Length: 3⁄4"-2"

Capacity: 100

To load your nailer:

1.Disconnect the air supply from the nailer!

2.Slide back the magazine pusher until it stops as shown in Figure 2.

Figure 2. Releasing magazine pusher.

3.Load a nail stick in the T-slot at the top of the magazine as shown in Figure 3.

4.Release the magazine pusher by pulling it back, depressing the release button, and sliding it forward.

Figure 3. Loading finish nails into nailer.

-6- H5570 18 Gauge Finish Angle Nailer