Installation
NOTE:
•Do not rest your arm on the monitor or lean against the monitor.
•Do not hold the LCD panel when installing the monitor.
•Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor or injury.
•The illustrations of the monitor is of
7Using the monitor on the stand
You can place the monitor in the following two ways when using the monitor on the supplied stand.
ENGLISH
You can tilt the monitor upward or downward within the range of about 20° in each direction.
about 20°
about 20°
NOTE:
•Be careful not to pinch your fingers in the gap between the monitor and the stand.
•Do not tilt the monitor upward more than 20°; otherwise the monitor may fall over.
•When the monitor is attached to the lower position of the stand (see below), you cannot tilt the monitor downward.
When the monitor is attached to the higher position of the stand (see below), you can lift the stand up by 90° and place the monitor as illustrated below.
NOTE:
•Be careful not to pinch your fingers in the moving parts.
•Make sure to lift the stand up until it stops; otherwise the monitor may fall over.
•Place the monitor on a mat to avoid scratching the table surface.
•Do not place the monitor in this way when the monitor is attached to the lower position of the stand.
To adjust the stand height
You can select the stand
• For how to detach the stand, see below.
To detach the stand
NOTE:
•Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel being damaged.
Screw holes for lower position
Screw (M4 x 10) 
VESA mounting holes
Screw holes for higher position
Stand
Monitor
11
