![](/images/new-backgrounds/1127165/12716519x1.webp)
Controls and Features (cont.)
7Rear panel
a | b c d |
2
3
e f g h
45
6
The illustration of the monitor is of
1
1AC inlet
Power input connector. Connect the provided AC power cord to an AC outlet (AC 120 V/AC 220 - 240 V, 50 Hz/60 Hz).
2VIDEO terminals
a VIDEO 1 terminals (BNC)
Input (IN) and output (OUT) terminals for the composite signals.
•The IN and OUT terminals are bridge- connected (auto termination).
•Use the AUDIO 1 terminal* for the audio connection.
bVIDEO 2 terminals (BNC)
Input (IN) and output (OUT) terminals for the composite signals.
•The IN and OUT terminals are bridge- connected (auto termination).
•Use the AUDIO 2 terminal* for the audio connection.
cAUDIO 1 terminal (pin jack)*
Input terminal for the analog audio signals.
•Use the VIDEO 1 terminal for the video connection.
dAUDIO 2 terminal (pin jack)*
Input terminal for the analog audio signals.
•Use the VIDEO 2 terminal for the video connection.
3REMOTE (external control) terminal (MAKE/
TRIGGER)
Terminals for controlling the monitor by an external control.
•Enables the monitor to be controlled by short- circuiting the pin terminal in this terminal or by inputting the pulse signal.
☞“How to Use the External Control” on page 17
4DVI-D terminals
eAUDIO terminal (stereo mini jack)* Input terminal for the analog audio signals.
NOTE:
• The
fDVI-D terminal
Input terminal for the DVI-D signals.
NOTE:
•Use a
5RGB terminals
gAUDIO terminal (stereo mini jack)* Input terminal for the analog audio signals.
NOTE:
• The
hRGB terminal
Input terminal for the analog RGB signals.
6Security slot
Install a security wire to this slot.
* Equipped on
10