OPERATIONS
Loading
When replacing nails in your Model H7665, follow these guidelines:
Type: Round Head
Angle: 21°
Diameter: 0.113"
Length:
Capacity: 75
To load your nailer:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
2.Slide the magazine back, as shown in Figure 3, until it locks in place.
Magazine
Handle
Figure 3. Sliding magazine back and
engaging the catch.
3.Insert a strip of nails, pointed-end down, into the magazine as shown in Figure 4.
Magazine
Catch
Figure 4. Loading nails into magazine.
4.Slide the nails all the way down to the nose of the nailer.
5.With one hand on the magazine handle for control, release the magazine catch and slowly allow the magazine to press against the nails. Note: Releasing the magazine catch and allowing it to "snap" in position is hard on the nailer.
H7665 21° Round Head Framing Nailer |
