Grizzly H7665 instruction manual Troubleshooting, Symptom Possible Cause Solution

TROUBLESHOOTING

Symptom	Possible Cause		Solution
Air leaking at trig-	1. O-rings in trigger valve hous-		1.	O-rings must be replaced
ger valve area.		ing are damaged.		& operation of safety nose
				must be checked.
Air leaking between	1. Loose screws in housing.		1.	Tighten screws.
housing and hose.	2. Damaged O-ring.		2.	Replace O-ring.
	3.	Loose air fitting.	3.	Tighten air fitting & use tef-
				lon tape.
Air leaking between	1. Damaged seal.		1.	Replace damaged seals.
housing and cap
assembly.
Tool skips nails	1. Air leaks.		1.	Tighten screws and fittings.
while discharging.	2. Dirt in nose.		2.	Clean nose.
	3.	Dirt or damage prevents nails	3.	Clean magazine and
		from moving freely in maga-		inspect/repair damage.
		zine.
	4.	Inadequate air flow to tool.	4.	Check fitting, hose, com-
				pressor & air pressure.
	5.	Worn O-ring on piston or lack	5.	Replace piston O-ring.
		of lubrication.		Lubricate.
	6.	Damaged O-rings on trigger	6.	Replace trigger valve O-
		valve.		rings.
	7.	Worn bumper.	7.	Replace bumper.
	8.	Cap seal leaking.	8.	Replace cap seal.
Tool runs slowly	1. Nailer is not sufficiently lubri-		1.	Lubricate nailer.
or has a loss of		cated.
power.	2. Broken spring in cap assem-		2.	Replace spring.
		bly.
	3.	Exhaust port in cap is blocked.	3.	Clean or replace damaged
				internal parts.
Fasteners frequent-	1. Nails are the wrong size.		1.	Use correct nails.
ly jam the nailer.	2. Nails are bent or dirty.		2.	Use undamaged, clean
				nails.
	3.	Magazine or nose screws are	3.	Tighten magazine.
		loose.
	4.	Driver or driver guide are worn	4.	Replace worn or damaged
		or damaged.		parts.
	5.	Nails are wrong angle.	5.	Use correct angle nails.
Nailer does not fire.	1. Nail is jammed in magazine or		1.	Clear nailer magazine or
		discharge area.		discharge area.
	2.	Piston shaft is damaged.	2.	Replace piston shaft.
	3.	Air pressure too low.	3.	Check/increase air pres-
				sure.

H7665 21° Round Head Framing Nailer -15-