Grizzly H7668 instruction manual Symptom, Possible Cause, Solution

Symptom	Possible Cause		Solution
Excessive over-	1.	Fluid pressure too high.	1.	Reduce fluid pressure.
spray.	2.	Gun is too far from surface.	2.	Keep gun at recommended
				distance.
	3.	Spraying too fast.	3.	Slow down and maintain
				consistent, even parallel
				stroke.
Unable to control	1.	Pattern adjustment screw is	1.	Clean or replace.
spray fan.		not seating properly.
	2.	Atomizing cap is loose.	2.	Tighten atomizing cap.
Runs and sags.	1.	Damaged seal.	1.	Replace damaged seals.
Material leaks from	1.	Cap not secure.	1.	Tighten.
pressure cup.	2.	Hose connections not tight.	2.	Tighten.
	3.	Leaking from cap vent hole.	3.	Hold gun upright do not tilt.
Material leaks from	1.	Fluid tip loose.	1.	Tighten.
gun.	2.	Fluid hose connection is not	2.	Tighten.
		tight.
	3.	Dry or damaged seals.	3.	Replace seals.
	4.	Excessive pressure.	4.	Reduce pressure.
Thick dimpled finish	1.	Holding gun too close to sur-	1.	Spray at recommended dis-
aka "Orange Peel."		face.		tance.
	2.	Inlet air pressure too low.	2.	Check inlet air pressure.
	3.	Material not properly mixed.	3.	Follow manufacturer's
				instructions.
	4.	Surface is dirty or oily.	4.	More surface prep is
				required.
Dry Spray.	1.	Inlet air pressure too high.	1.	Lower inlet air pressure.
	2.	Gun too far from surface.	2.	Keep gun at recommended
				distance.
	3.	Gun stroke too fast.	3.	Slow down and maintain
				consistent even parallel
				stroke.
Gun leaks from	1.	Debris will not let the needle	1. Clean or replace both.
fluid tip.		seat with the fluid tip.
Excess pressure in	1.	Safety valve not working.	1.	Discontinue use!
pressure cup.			2.	Relieve pressure.
			3.	Replace safety valve.
Contaminated	1.	Water or oil in the air line.	1.	Install an in-line air filter.
paint, aka "Fish			2.	Replace air line.
Eyes.

Model H7668 Spray Gun w/Pressure Cup -19-