2.Position the workbench top "A" so the vise support bar is to your left. Using the 4mm hex wrench, Install leg "D" with two (X1) wood screws, and two (X2) washers (Figure 3). Do not fully tighten at this time.
Figure 3. Leg installation.
3.Install leg "B" with two (X1) wood screws, and two (X2) washers as previously done. Do not fully tighten at this time.
4.Insert two (W2) barrel nuts into the back cross brace "C", so the barrel nuts slots are horizontal and showing on the same side as the back board center slot (Figure 4).
Figure 4. Back board installation.
5.Position the back cross brace "C" so it is fac- ing inward and the grooves in the brace line up with the grooves in the legs.
6.Using the 5mm hex wrench, secure the brace and legs together with two (W1) barrel bolts and two (W3) washers (Figure 4). Do not fully tighten the bolts at this time.
-2-
7.Position the center panel "F" so the magnetic latches are facing toward the front (Figure 5), and the panel slips in the center slot.
Figure 5. Center panel installation.
8.Using the 4mm hex wrench, secure the cen- ter panel "F" to the cross brace with two (Z1) special cap screws and washers (Figure 5). Do not fully tighten at this time.
9.Position the bottom panel "G" into the leg grooves. Using care, slide the panel all the way back until it fully seats into the groove in the back cross brace "C" (Figure 5).
Figure 6. Bottom panel installation.
Model H7724 (Mfg. since 7/08)
