Grizzly H7761 owner manual Items Needed for Set Up, Mounting, Description Qty

Items Needed for

Set Up

The following items are needed to complete the set up process, but are not included with your machine:

Description	Qty
Wrench 8mm	1
Wrench 13mm	1
Hex Bolt M8-1.25 (length varies)	2
Flat Washer 8mm	4
Lock Washer 8mm	2
Hex Nut M8-1.25	2

Mounting

The Model H7761 weighs 22 lbs. Make sure the workbench on which you plan to mount the sander is sturdy enough to hold the weight of the machine and any downward pressure that may be applied during operation. The workbench should have a level surface and be heavy, or attached to the floor so that it will not move during operation.

Components and Hardware Required	Qty
Sander Unit	1
Hex Bolt M8-1.25 (length varies)	2
Flat Washer 8mm	4
Lock Washer 8mm	2
Hex Nut M8-1.25	2

The Model H7761 can cause personal injury if operated by untrained users. Ensure that your machine is inac- cessible to children and visi- tors by closing and locking all entrances to your shop/ garage when you are away.

NOTICE

When mounted, the storage tray can be eas- ily damaged if the grinder is tipped forward.

-10-

To mount the grinder:

1.Find the best place in your shop to mount the sander.

—Pick a spot on the workbench that will allow enough room to move the size of an anticipated workpiece around the sander. The operator (and possibly bystanders) should have enough room to stand out of the way.

—Mount the sander in an area with proper lighting and near electrical outlets. Lighting should be bright enough to eliminate shad- ow and prevent eye strain. Electrical cir- cuits should be dedicated or large enough to handle amperage requirements.

Note: Keep power or extension cords clear of high-traffic areas. If you install new light- ing, outlets, or circuits, observe all electrical codes.

2.Mount the sander to the workbench with bolts that are long enough to exceed the thickness of your workbench and the sander base. Secure each bolt with flat washers, a lock washer, and a hex nut as in Figure 3.

Note: Because sizes vary for each individual situation, the hardware in this step is not included with the Model H7761.

H7761
Base	Bolt
	Flat
Workbench	Washer
	Flat
	Washer
	Lock
	Washer
	Nut

Figure 3. Mounting machine to the workbench.

H7761 2" x 27" Belt & 6" Disc Combo Sander