Lubricating Sleeve Bearings | Grizzly H7761 guide

Lubricating Sleeve

Lubricate the sleeve bearing with 30 WT oil every 10 hours of operation. No other lubrication is nec- essary for this machine.

2.Remove the sanding belt.

3.Apply two or three drops of oil in the hole at the end of the idler pulley (Figure 15).

4.Wipe of any residual oil.

Note: DO NOT apply extra oil. Too much oil can cause the belt to slip.

-22-	H7761 2" x 27" Belt & 6" Disc Combo Sander

Image 24

Contents

Model H7761 Page Table of Contents Introduction ForewordContact Info Overall Dimensions FeaturesMotor Identification Safety Safety Instructions for Machinery Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety Instructions for Sanders Circuit Requirements 110V Operation SET UP Set Up Safety InventoryUnpacking Inventory Figure Qty Items Needed for Set Up MountingDescription Qty Components and Hardware Required Qty Hardware Recognition Chart Clean Up Weight LoadSite Considerations Working Clearance Installing Disc Table To install the disc tableAttaching Sanding Disc Components and Hardware Needed Qty Adjusting Miter Gauge To adjust miter gaugeAligning Table To align the table To install the sanding belt To test the tracking Installing Back Stop Installing Dust Collection HoseTo install the back stop To connect a dust port to a dust collection system Operations GeneralDisc Sanding Miter Sanding Angle Sanding To perform miter sanding operationsTo perform angle sanding operations Belt Sanding To perform belt sanding operations Accessories H1300 H1298 G7984 H2347 H073627 Silicon Carbide Sanding Belts Aluminum Oxide Sanding Discs Maintenance Maintenance SafetySchedule Lubricating Sleeve Bearings To lubricate the sleeve bearings Service Troubleshooting Breakdown Parts List Description Warranty and Returns Page Page