H7945/H7946/H7995 26° Angle Nailer
-6-
Compressed Air System
The Model H7945/ H7946/ H7995 is
designed to be operate d at 70–110 PSI
using clean, dry, regulated, compressed
air. DO NOT exceed 120 PSI.
Before using your new nailer, set the air
pressure on your regulator to the mini-
mum PSI for your model.
An in-line filter/lubricator/regulator unit,
depicted in Figure 2, can be ins talled and
should be located as close to the nailer
as possible.
This filter/lubricator/re gulator unit will pro -
tect your tool from damaging wa ter build-
up, allow you to adjust and main tain con-
stant air pressure to your tool, an d save
you the inconvenience of manually lubri-
cating your tool every time you use it.
Quick
Connector
Quick
Coupler
Air Hose Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2. Typical filter/lubricator/regulator installation order.
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install -
ing a filter /lubricator/regulator unit in your
compressed air system, always fol low the
connection instructions that come with
the unit.
Exceeding the maximum permissible
operating pressure may damage the
seals, gaskets and hammer mecha-
nism of your nailer. DO NOT allow
your air compressor to exceed the
recommended pressure when con-
nected to this nailer or serious per-
sonal injury may result!