OPERATIONS
Model H7949/H7950
Loading Nails
Use nails meeting the specifications listed for your nailer on Page 4 of this manual.
To load nails in your nailer:
1.DISCONNECT NAILER FROM THE AIR SUPPLY!
Point the nailer away from you and others when connecting the air supply. The nailer can cycle and discharge a nail when the air supply is connected. Ignoring this warning may result in serious personal injury.
2.Pull the magazine open from the cover tab as shown in Figure 3.
Magazine
Cover Tab
Figure 3. Opening the magazine: Model
H7949/H7950.
3.Press the adjusting pin inside the magazine and slide the plate up or down until the plate position matches the nail length as shown in Figure 4.
Note: The plate must be set at the proper height or the nails will not feed smoothly into firing position.
| Nail Length |
| Marks |
Magazine | Adjusting |
Plate | Pin |
Figure 4. Positioning the magazine plate.
4.Place the nail coil into the magazine and uncoil enough nails to reach the driving hole as shown in Figure 5.
Driving
Hole
Figure 5. Loading nails in the magazine.
H7949/H7950/H7951 Nailer |
